Frame-Mounted Agitator Drive — Mounting & installation

FMA — Mounting Configurations

Mounting configuration is order-specific. Confirm shaft orientation, interface dimensions, lubrication position, and installation instructions against the approved order drawing before installation.

Pre-installation checks

Verify shaft orientation matches the order specification
Inspect for transit damage before mounting
Confirm foundation flatness and bolt grade
Check oil fill level (units ship without oil unless specified)

Commissioning

Follow the model- and application-specific commissioning procedure confirmed for the order; this placeholder page does not define a universal run-in interval.

Related resources

Need a gearbox configuration for your machine?

Send the required motor power, input speed, target output speed or ratio, expected output torque, mounting arrangement, and any installation drawing available. CHINFAR can use these inputs to narrow the R/F/K/S configuration before final engineering confirmation.

Submit your inquiry